1. Read work-related information/instructions via e-mail
2. Use entry-to-end intercom system
3. Signal team member via bell and light system
4. Read and interpret emergency evacuation procedures
5. Report (in writing) problem and/or solutions
6. Prepare shop order requests
7. Read and interpret Job Safety Analysis (JSA)
8. Communicate with team

1. Read and interpret work orders
2. Acquire and prepare materials
3. Load rolls into machine
4. Sew Material onto threaded material
5. Thread through mangle; fill mangle with chemical
6. Monitor equipment for out-of spec operation
7. Package untreated waste
8. Monitor and record daily product

1. Tears/inconsistencies in fabric
2. Contamination of chemicals during operation
3. Troubleshoot guiders

1. Visually inspect material
2. Cut sample for each doffed roll
3. Replace slitter knife assembly
4. Monitor equipment for out-of spec operation
5. Clean selvage and out-trim pipes
6. Package treated waste

1. Selvage rips; rolls inconsistent

1. Wrap finished slits
2. Operate lift truck
3. Clean out trim room

1. Read and interpret mix (specifications) sheet
2. Weigh out liquid and chemicals per mix sheet
3. Activate signal lights, identify proper tank for pads

1. Reset Gas
2. Troubleshoot Bad Clips
3. Check bearings (entry and exit)
4. Check oil on chain
5. Repair and troubleshoot Steam Cans
6. Troubleshoot and repair Rotary Joints
7. Change belt (fans)
8. Troubleshoot and repair line leaks
9. Minor repair air leaks/line (pneumatics)
10. Assist in tear down
11. Calibrate Stretch Monitor

1. Keeping area, walkways, and machines clean to enhance safety and product quality
2. Entry End
3. Exit End
4. Utility
5. Shipping

1. Large Reroll
2. Small Reroll
3. Troubleshoot Reroll

1. Research and Development (assistance)
2. Team Meeting

1. (Fraction, Decimals, Division, Multiplication, Percents, Ratio and Proportion) 2. Standard Measurement/Temperature 3. Advanced Math (Basic Algebra, Basic Geometry)

1. Writing/Reading 2. Comprehension Skills 3. Oral Communication Skills 4. Computer Skills

1. Preparing Chemical Solution 2. Terminology 3. Understanding Reactions 4. Safety Hazards

1. Basic Machine Principles, 2. Principles of Mechanics, Lubrication, 3. Hydraulics, Pneumatic