1. Care and use of tools 2. Test and measurement devices 3. Types and sizes of piping, tubing, fittings 4. Introduction to refrigeration components 5. Safety procedures, and first aid procedures 6. Equipment records and reports

1. Cut, thread, flare, bend, shape piping and tubing 2. Install fittings 3. Solder, braze, tin fittings and components 4. Care and use of oxy-acetylene and prestolite torches 5. Silver and soft soldering

1. Electric supply lines and cables 2. Electrical connections 3. Water service line 4. Air supply line 5. Steam line 6. Steam return line 7. Steam traps and strainers 8. Pressure reduction, expansion, evaporator, stop valves 9. Suction and discharge lines 10.Gauges 11.Dehydrators 12.Filters and strainers 13.Controls

1. Install condensers 2. Prepare compressors and motor bases 3. Install and align compressors and motors 4. Install evaporators and other cooling coils 5. Install and align centrifugal pumps and pump bases 6. Use of slings, lines, blocks and falls, chain hoists, rollers, dollies and skids

1. Troubleshoot field systems 2. Test pressure, flow etc. 3. Check liquid levels 4. Check, repair leaks (freon, liquid) 5. Purge, dehydrate, chrage systems 6. Repair, align, adjust fans and blower sections 7. Align pulleys, bearing blocks, belt tension

1. Disassemble and clean, repair/renew, perform shop tests and run-in compressors 2. Repair, pressure test, dehydrate evaporators 3. Repair, acidize condensers, roll condenser tubes 4. Remove, replace, disassemble, test, clean, calibrate, renew defective parts on controls of all types, such as: a. Pneumatic b. Electrical c. Electro-Pneumatic d. Thermostatic e. Humidity f. Pressure g. Vacuum

1. Supply systems 2. Return systems 3. Introduction to duct systems – for central air conditioning (fire dampers, etc.) 4. Installation of controls (pressure, temperature) 5. Leak testing (vacuum pressure)

1. Orientation 2. Housekeeping 3. Safety 4. Activity not otherwise listed

1. First Aid - minimum 6.5 hours every 3 years 2. Asbestos Awareness – minimum 4 hours (see attachment) 3. Sexual Harassment Prevention – must comply with Section 201-g of the Labor Law

1. Practical artimetic 2. Basic algebra 3. Plane Geometry 4. Trigonometry

1. Reading Blueprints 2. Elementary architectural drawing 3. Drawing and sketching 4. Specification writing

1. Pipes and fittings 2. Pipework 3. Principles of heating, ventilating and air conditioning 4. Fractional horsepower motors 5. Principles of refrigeration 6. Refrigeration and air conditioning servicing 7. Controls for air condition 8. Estimating 9. Refrigerants 10.OSHA: Occupational Safety and Health Act 11.A.C. and D.C. Motors